| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Vehicle Interior | Section: Seat | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002XDP002X |
| Title: SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): REMOVAL (2008 Sequoia) | ||
REMOVAL
HINT:
- Use the same procedure for the LH side and RH side.
- The procedure listed below is for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
-
When disconnecting the cable some systems need to be initialized after the cable is reconnected
.
- After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE FRONT SEAT HEADREST ASSEMBLY
3. REMOVE SEAT TRACK COVER INNER LH
(a) Operate the seat track adjusting handle to move the seat to the foremost position.
|
(b) Using a screwdriver, disengage the 2 claws and remove the seat track cover. HINT:
Tape the screwdriver tip before use. |
4. REMOVE SEAT TRACK COVER LH
|
(a) Using a screwdriver, disengage the 2 claws and remove the seat track cover. HINT:
Tape the screwdriver tip before use. |
5. REMOVE FRONT SEAT ASSEMBLY LH
|
(a) Remove the 2 bolts. |
(b) Operate the seat track adjusting handle to move the seat to the rearmost position.
|
(c) Remove the 2 bolts. |
(d) Operate the seat track adjusting handle to move the seat to the center position.
(e) Disconnect the seat wire connectors under the seat.
(f) Remove the front seat.
NOTICE:
Be careful not to damage the vehicle body.
|
|